#Flashcode engie code#

#Flashcode engie code#

The reset switch is located behind the electrical unit board.Check that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0–1. ECU memory is now erased.MID-TICS SystemRelease diagnostic switch.Place ignition switch in On position.Check that Overheat Warning Lamp is displaying Diagnostic Display Code.Connect memory clear connector(#) #-#09, or a suitable jumper wire to reset switch terminals. The ECCS system is now in mode 2.Turn the diagnostic mode selector on the ECU fully clockwise and wait more than two seconds then turn the selector fully counterclockwise. Each trouble code will be displayed 3 times before the next trouble code is displayed.Ĭlearing Trouble Codes Turn the ignition key on.Turn the diagnostic mode selector on the ECU fully clockwise and wait more than two seconds then turn the selector fully counterclockwise. For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a.

Trouble Code InterpretationMID-TICS SystemThe diagnostic trouble codes will be displayed by the check engine lamp. Nissan UD DieselID-TICS SystemPlace diagnostic switch in the Off position.Carry out diagnosis under the following three conditions:Place ignition switch in the On position.Crank engine.Start and operate engine.The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer. 108 Canister Purge Control Valve Circuit.105 EGR and EGR Canister Control Solenoid Valve Circuit.103 Park/Neutral Position Switch Circuit.101 Front Heated Oxygen Sensor Heater Circuit right hand bank.91 Front Heated Oxygen Sensor Heater Circuit right hand bank.87 Canister Control Solenoid Valve Circuit.86 Fuel Injection System Function right hand bank.76 Fuel Injection System Function right hand bank.36 EGR Control-Back Pressure Transducer.11 Crank Angle Sensor/Camshaft Position Sensor.Diagnostic Display Code 0-1 should be indicated. Turn ignition On, then observe Overheat Warning Lamp and Buzzer. Remove connector or jumper wire from reset switch electrical connector.Ĭonnect electrical connector to reset switch. The System memory will be cleared in approximately 10 seconds. The reset switch is located behind the electrical unit board.Ĭheck that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0-1. Nissan UD Diesel: Clearing Diagnostic Trouble Codes MID-TICS SystemĬheck that Overheat Warning Lamp is displaying Diagnostic Display Code.Ĭonnect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer. Place diagnostic switch in the Off position.Ĭarry out diagnosis under the following three conditions: Nissan UD Diesel: Accessing Diagnostic Trouble Codes ID-TICS System Each trouble code will be displayed 3 times before the next trouble code is displayed. For example, a code 12 will be displayed by the Check Engine lamp flashing 1 time for approximately 1.2 seconds, followed by a. The diagnostic trouble codes will be displayed by the Check Engine lamp.

Nissan UD Diesel: Diagnostic Trouble Code Interpretation MID-TICS System